Fuel and Cooling

So You Bought an Edelbrock Carburetor

I have long held the opinion that the Carter AFB carburetor was the best carb for our V8 Studebakers. They are easy to tune and are economical. However, they are no longer being made. Edelbrock has a solution. The company cloned the AFB (well almost) and many people have said that they work perfectly right out of the box. The recommended one for most Studebaker 259s and 289s is the 1403 model with an electric choke. THESE CARBURETORS RUN RICH. i.e they use more fuel! Out of the box, they are set up to perform on a 350 Chev which uses a lot more fuel than our Studebakers. I found also that the out of the box setting for the floats is out of whack. What tipped me off to this was the small puddle of fuel in one of the depressions in the intake manifold at the front of the carburetor. So I took the top off the Edelbrock (torx screws) and discovered that the float was set at 3/8” on one side and just under 3/8” on the other. Not good. I adjusted them both to read 7/16” and the factory setting for the float drop was also away off. It should read around 15/16” to 1”. I found a large discrepancy here so I adjusted the float drop to specifications. It seems that the Edelbrock factory has a bit of a problem with quality control, not in the hard parts but in the assembly and settings.

My recommendation, if you buy an Edelbrock carburetor, is to disassemble it and check that the settings are correct before you install it. Obviously, some of these carburetors assembled by Edelbrock are correct and this would account for the statement that they work right out of the box but I would check your new purchase before putting it on your engine.

The next step is to find out how your vehicle performs. Does it still use too much fuel? If so, you may want to invest in a metering rod/jet tuning kit sold by Edelbrock. This will allow you to try different metering rod combinations to adjust the carb to produce the desired results.

The manual supplied by Edelbrock has an excellent tuning section that is easy to understand. My recommendation is to try the metering rods only and not fool with the actual jets unless you are more experienced in their installation.

More in Fuel and Cooling

Stuck on a problem with your own car?

Ask Our Tech Advisor