Fuel and Cooling

12-Volt Electric Choke Conversion

I recently converted the automatic choke on my Carter AFB to an electric unit. It is made by Allstate Carburetors. I purchased it over the Internet at http://www.allcarbs.com/detail.php?pid=97. These are good people to deal with. Very prompt delivery. This is an inexpensive unit and very easy to install. It comes with a new set of screws and clips as well as a new gasket.

All that you have to do is remove the old plastic cover and replace it with the new unit. Then you run a wire from the new choke to a good ground. You will need a power source. They are clearly marked for positive and negative terminals. I used the battery side of the ballast resistor to run a wire to the positive terminal so that when you turn the key on there is power.

Final step is to adjust the choke. Wait for the engine to be completely cold, then turn the new choke cover so that the choke closes, then lock it in place by tightening the three cover screws. Try it out. Your engine should fire quicker and the choke will come off quicker now.

More in Fuel and Cooling

Stuck on a problem with your own car?

Ask Our Tech Advisor