Fuel and Cooling
Fuel Economy
With gasoline prices skyrocketing to around $1.50 per litre (which is $6.80 per imperial gallon to us old folks) for ethanol free fuel, it is becoming increasingly costly to operate our collector vehicles. Fortunately we somehow seemed to have selected a marque that is inherently economical. After all Studebaker won the Mobil Gas Economy Run with all their vehicles. It seems that Studebaker engineers were onto a good thing when they designed vehicles to be low cost to operate. They started by reducing weight and using smaller engines and they were one of the first to market the overdrive transmissions. All this contributed to fuel economy. Many of the cars that Studebaker made were capable of 30 miles per gallon. Today, we have to be very conscious of the fuel that we use and how to be frugal with it. I do not claim to have any innovative ideas for improving your fuel economy but maybe a refresher is needed for everybody in order to coax the maximum of mileage from our vehicles.
-
Ensure that tires are inflated to the best pressure (usually a couple of pounds greater than factory specs).
-
Use synthetic oil of lower viscosity such as 10W-40.
-
Use synthetic oil in your transmission. I have had success with Royal Purple Synthetic Transmission fluid.
-
Use Synthetic oil in your differential. Again I use Royal Purple Synthetic 75W140 oil.
-
Make sure that your air cleaner is clean. Use new oil in an oil bath type and put in a new element in the replaceable type.
-
Advance your ignition timing about 2 degrees more than factory specs.
-
Drive your vehicle responsibly with no jack rabbit starts (except for me at the drag strip!)
-
Limit your speed to the sweet spot where your engine produces the most power with the best economy. This is done by reducing engine rpm to the lowest number while still maintaining a good speed.
-
Try to find a rear axle ratio that will allow your engine to run lower RPMs i.e. a 4.27 ratio instead of a 4.56 gear with overdrive on a six cylinder vehicle.
-
A similar rear axle ratio for a V8 vehicle with overdrive is to use a 3.73 rear axle instead of the 4.55 ratio that came from the factory. Believe me a good V8 will perform quite well with a higher gear and besides, with overdrive you can always kick it down to conventional if you need more oomph!
Now that I have given you some thoughts about what I think is possible it is up to you to come up with other ideas to reduce the profit margins of the greedy oil companies.
Tech Tip: Valve Cover Seal
When removing and re-installing valve covers on your Studebaker V8 engine use the neoprene gaskets. You can re-use these gaskets many times if you affix the gasket to the valve cover using adhesive or shellac. This way the gasket comes off with the valve cover.
To avoid leaks when re-installing the covers, wipe the gasket and the metal surface on the cylinder head with liberal amounts of brake cleaner to remove any oil. Wipe both surfaces so that they are clean and dry. Do not over tighten the hold down nuts. You will have no leaks.
More in Fuel and Cooling
Stuck on a problem with your own car?
Ask Our Tech Advisor