Engine and Oil
My Seven-Cylinder Studebaker V-8
When I set out on my trip to the International Meet in Warwick Rhode Island in my 1964 Champ truck, I noticed a surge and stumble upon acceleration. I put it down to the engine being cold. Not so. It continued to stumble somewhat, even when warm. Otherwise, it ran quite well.
At the first stop for fuel, the Champ seemed to have used much more fuel than I thought it would but again I put it down to being hot weather and the A/C in constant use. It seemed to get better when the engine was fully warmed up. Not to worry. On the return trip (1,000 miles round trip) it did the same thing and gulped fuel far more than it should have. I thought that maybe I was mistaking American gallons but that was not the case; the truck just used more gas.
At Warwick I made some purchases for the Avanti and the truck at the swap meet and then again at Autozone where I bought new spark plugs. I stopped at the usual line-up to cross the border at Customs and noticed the heat gauge rising so I applied slight pressure, while in neutral, to the gas pedal to speed up the engine a little. That is when I detected a bit of a shake in the engine that I had never experienced before. Not to worry, we are almost home. After I got home and the engine had cooled down, I decided to install the new sparkplugs that I had bought. (Probably the subject for another article.) Now understand, because of my racing habits, I constantly monitor the spark plugs in the engine, usually one or two. Naturally I always select the easy access ones. They have always looked good in the past so I was convinced that I did not have a timing or ignition problem. Not so. This time I started at the front of the engine, number 2 to be precise, because it was the worst plug to access due to my A/C bracketry. When I pulled it out, it had a fair amount of fluffy black carbon on the electrode.
I made a note of this and then proceed to remove the rest of the plugs. All seemed OK (after all, these were less than two years old) and my thoughts were directed to the number 2 plug with the fluffy carbon. Obviously something was wrong, but what? Was it a faulty plug or a faulty plug wire (next on my to do list)? After all the new plugs were installed, I test drove the truck. What a difference! No sign of surging or hesitation, etc. The new plugs appear to have cured the problem. But looking once again at the number 2 plug, there does not appear to be a problem with it other than the fluffy carbon on the electrode. My guess is it is a defective sparkplug. It looks good but isn’t. The moral to this story is: don’t take things for granted. Appearances are deceiving.
In the old days at the local garage, we had a Champion sparkplug tester which applied air pressure to simulate compression pressure in an engine. If the plug did not produce a big spark when the pressure passed 150 lbs., we replaced the plug no matter how good it looked. Plugs somehow have a way of looking good but do not work properly. Now to replace my plug wires. Something you should investigate. Don’t let that fine Studebaker engine waste fuel unnecessarily. One thousand miles round trip using only seven of the eight cylinders!
More in Engine and Oil
Stuck on a problem with your own car?
Ask Our Tech Advisor