Gauges and Electrical
Ignition System
All four stroke engines operate with the same cycle, i.e. “Suck, Squeeze, Pop, Poof” or induction, compression, ignition, exhaust. In this article we will concentrate on the Pop or ignition cycle. Studebaker V8 engines came with either Prestolite or Delco distributors. When these were new they worked quite well but over time, and our cars are over 50 years old, these systems tend to wear out. A worn distributor can cause hard starting, poor fuel mileage and a rough idle.
The simple check with timing light will tell you a lot about your distributor’s condition. Hook up your timing light and aim at the timing marks and if the marks appear to jump around instead of being steady on the timing marks this is an indication of a worn out distributor or at least the weights within the distributor are worn out. Worn weights are usually noticed in the Prestolite distributors. The pivot points in the weights become elongated and the weights no longer operate smoothly causing erratic timing. The simple solution is to obtain a set of Chrysler weights which have bronze bushings in the pivot points and fit well with little or no apparent wear.
The shafts on both the Delco and Prestolite distributors have bearings which also can wear and the test for worn shaft bearings is to move the top of the shaft to check for “play”. Getting the distributor shafts bearings replaced is a job best left to a machine shop but there is an alternative. The new MAXX distributor. Yes it is made in China but it is of very high quality. For most Studebaker applications it can be used right out of the box but if you happen to have a supercharged engine you will need to swap out the springs to the lightest ones and be careful to install it with no more than 10 degrees of static advance timing. I.e. 10 degrees with vacuum line disconnected and engine idling at 550rpm.
If you can refurbish your old distributor you can keep your vehicle all original but for as new performance I suggest replacing the Prestolite or Delco distributor with the MAXX distributor. These Chinese distributors are a great drop in distributor for our Studebakers and can put some fresh zip into your engine with better starting and smoother idle. Put some new “Pop” into your four stroke cycle!
More in Gauges and Electrical
Stuck on a problem with your own car?
Ask Our Tech Advisor